PREMARK roll white - 5000*100mm

Attachment to asphalt:
1. Clean the surface with a brush. The surface must be free of dust, chemicals, oils, and similar substances that can reduce adhesion. If the surface is damp, it must be dried with a torch.
2. Remove the protective film and place the PREMARK® at the desired location.
3. Heat the PREMARK® marking with a gas torch, moving the torch back and forth until the marking bubbles. Only then is it sufficiently melted. NOTE: Do not heat in spots; this can cause overheating and discoloration of the base layer.
4. When the PREMARK® is sufficiently heated, glass beads or friction material or their combinations can be sprinkled onto it.
5. The road marking is ready.